ESTLCAM CNC Controller AC-CNC2017-2S-REV5.1x

For ESTLCAM 10 and 11.2xx

The control card has the following connection options:

• Motor driver Step X Y Z also several drivers per output e.g. 2 motors on Y axis
• Dir X Y Z also multiple drivers per output
• 8 in ESTLCAM 11 freely adjustable inputs, sensors, limit switches, stylus, touch plate, start, stop, etc.
• Output 1 and 2 (e.g. for suction, cooling water, laser, etc.)
• Output to switch a relay for a milling motor
• 0-10V / 0-5V Output for frequency inverter (adjustable)
• DCM / FOR for frequency inverters - Adjustable
• Additional voltage output Output 6V
• 12V input
• Inputs Poti, Feed and Speed over ride
• Connection for push button - Hardware reset

The Nano is of course plugged in and not firmly soldered, should there be any problems, it can simply be replaced.

Further information / FAQ / comments and customer pictures can be found at: ArduinoClub ESTLCAM Control Card REV5.1x

Take a look at the connection diagram : Diagram